FIX Z XTREM Stud Anchor
FIX Z XTREM Anchor adalah jangkar ekspansi yang dikontrol torsi dan memiliki bagian pull-down yang terintegrasi, yang dirancang untuk kinerja tinggi dalam aplikasi beban statis dan dinamis, baik pada beton retak maupun beton yang tidak retak. FIX Z XTREM Anchor sangat cocok untuk pemasangan pada beton ketika keamanan dan keandalan menjadi hal yang utama.
Fitur dan Manfaat
- 3 legs clip for a better expansion
- 6 lugs for a better fixing in concrete
- Improved efficiency with fewer hammer blows and turns for installation
- “Pull down” capabilities for secure fixing
Material & Aplikasi
Substrates
- Concrete (cracked and non-cracked), Solid Stone (applicable with care)
Installation
- Drill the correct diameter hole to the same diameter as the FIX Z stud anchor
- Remove debris from hole by blowing out with compressed air or hand held blow out
- Install the anchor in the hole with a hammer until washer seats on
- Tighten bolt with a torque wrench to recommended assembly
Typical Applications
- Structural beams and columns
- Load bearing zones
- Cable trays
- Overhead piping
- Air condition ducts
- Securing of machines and equipment
- Tie back brackets for façade
Jadilah yang pertama memberikan ulasan “FIX Z XTREM Stud Anchor”
Spesifikasi & Data Teknis
| Thread Ø | Embedment Depth (mm) | Torque (Nm) | Shear Load (kN)* | Tension Load (kN)* |
| M8 | 46 | 20 | 4.6 | 3.8 |
| M10 | 60 | 45 | 5.3 | 8.4 |
| M12 | 70 | 60 | 7.7 | 12.5 |
| M16 | 85 | 110 | 15.0 | 16.6 |
| M20 | 100 | 160 | 20.4 | 21.3 |
* Safety factor for all loads = 3
* This table does not consider edge distance and anchor spacing effects. Please refer to Ramset Design Guide for more information.
* Pull out test for single anchor = working load x 1.5
Ulasan
0.0 Average Rating Rated ( 0 Review )
Belum ada ulasan.